M S ( Mild Steel) Angle

M S Angle

Steel Angles are the most basic type of roll-formed steel. They are formed by bending a single angle in a piece of steel.  Angle Steel is ‘L’ shaped; the most common type of Steel Angles are at a 90 degree angle. Steel are used for various purposes in a number of industries. Framing is one of the most common uses for steel angles, but steel angles are also used for brackets, trim, reinforcements, and many other uses. The larger the steel angle, the more weight and stress it can bear. The legs of the “L” can be equal or unequal in length. STC exports/supplies all the sections mentioned in the table below.

Zinc Ingots, Zinc Jumbo slabs, PM Plates, Prime Plates, Second Quality Plates, Crane Rail, Rail, Defective Rail, Angle, Channel , TMT Rods

Structural Steel Section

Rationalized Sizes Of Angles

Section Dimensions mm Sectional Weight Kg/m Length m
Angles 50 X 50 X 5* 3.8 12 & Above
50 X 50 X 6 4.5
60 X 60 X 5/6/8* 4.5/5.4/7.0
65 X 65 X 5* 4.9
65 X 65 X 6/8//10 5.8/7.7/9.4
70 X 70 X 5/6* 5.3/6.3
75 X 75 X 5/6/8//10 5.7/6.8/8.9/11.0
80 X 80 X 6/8/10 7.3/9.6/11.8
90 X 90 X 6/8/10 8.2/10.8/13.4
150 X 150 X 16/20* 35.8/44.1

*Can be produced,if sufficient orders are available

Below 10m/11.5m length can also be supplied

While standard length are mentioned in table above, it can supply material in any fixed lengthin the range 6-13m and DSP can supply in any fixed length in the range 5.5-11.5m

Common Grades:IS 2062/2011 and SAILMA

Copper bearing structurals are also rolled as per customer'specifications. High strength light structurals are also available as per the needs of TLT manufacture

Structurals are also available in the following foreign specification:

ASTM-A-36, JIS-G-3101-SS400,BS-4360 Grades 40A ,43B, 43C, 50B, 50C,EN-10025, Grades S-275 JO,JR,S-355 JO, JR, DIN-17100 ST 37.2/44.2 (all in semi-killed quality), if sufficient orders are available.

Rolling Tolerence For Structural Steel Section As Per IS:1852


Leg Length Tolerence Leg Length Camber
Up to 45mm/td> +- 1.5mm < 100mm As per agreement
>45 mm to 100 mm +-2.0mm >= 100mm 0.2 % of length
>100mm +-2%